Standard
Historical
Last Updated: Oct 24, 2019
Track Document
ASTM A1038-17
Standard Test Method for Portable Hardness Testing by the Ultrasonic Contact Impedance Method
Standard Test Method for Portable Hardness Testing by the Ultrasonic Contact Impedance Method
A1038-17
ASTM|A1038-17|en-US
Standard Test Method for Portable Hardness Testing by the Ultrasonic Contact Impedance Method
Standard
A1038 Standard Test Method for Portable Hardness Testing by the Ultrasonic Contact Impedance Method>
new
BOS Vol. 01.05 Committee A01
$
86.00
In stock
Significance and Use
4.1 The hardness of a material is a defined quantity having many scales and being dependent on the way the test is performed. In order to avoid the creation of a new method involving a new hardness scale, the UCI method converts into common hardness values, for example, HV, HRC, etc.
4.2 The UCI hardness test is a superficial determination, only measuring the hardness condition of the surface contacted. The results generated at a specific location do not represent the part at any other surface location and yield no information about the material at subsurface locations.
4.3 The UCI hardness test may be used on large or small components at various locations. It can be used to make hardness measurements on positions difficult to access, such as tooth flanks or roots of gears.
Scope
1.1 This test method covers the determination of comparative hardness values by applying the Ultrasonic Contact Impedance Method (UCI Method).
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.