Standard
Historical
Last Updated: Feb 23, 2021
Track Document
ASTM A801-14
Standard Specification for Wrought Iron-Cobalt High Magnetic Saturation Alloys (UNS R30005 and K92650)
Standard Specification for Wrought Iron-Cobalt High Magnetic Saturation Alloys (UNS R30005 and K92650)
A0801-14
ASTM|A0801-14|en-US
Standard Specification for Wrought Iron-Cobalt High Magnetic Saturation Alloys (UNS R30005 and K92650)
Standard
A801 Standard Specification for Wrought Iron-Cobalt High Magnetic Saturation Alloys (UNS R30005 and K92650)>
new
BOS Vol. 03.07 Committee A06
$
86.00
In stock
Abstract
This specification covers wrought iron-cobalt high magnetic saturation alloys, UNS R30005 and UNS K92650, for use in magnetic components requiring high permeability or high magnetic saturation. It covers material supplied in form of forging billets, hot-rolled products cold-finished bars, and strip. The material shall conform to the chemical requirements prescribed in this specification. Chemical analysis shall be performed for carbon, nitrogen, sulfur, and oxygen contents. DC magnetic property,which is the magnetic flux density of the material, shall meet the requirements prescribed in each type of alloys.
Scope
1.1 This specification covers two wrought iron-cobalt alloy types for use in magnetic components requiring high permeability at and above 15 kG (1.5 T) or high magnetic saturation. The specific alloy types covered are:
| Alloy Type | UNS | Nominal Composition |
|
|
|
|
| 1 | R30005 | 49 % Co, 49 % Fe, 2 % V |
| 2 | K92650 | 27 % Co, 0.50 % Cr, balance Fe |
1.1.1 This specification also covers material supplied by a producer in the form and physical condition suitable for fabrication into parts that will later be given final heat treatment to achieve the desired magnetic characteristics and, where required, mechanical properties. It covers material supplied in form of forging billets, hot-rolled products (that is, bar, plate, and strip), cold-finished bars, and cold-rolled strip.
1.2 This specification does not cover parts produced by casting or by powder metallurgical techniques.
1.3 The values stated in customary (cgs-emu and inch-pound) units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.