Standard
Historical
Last Updated: Mar 06, 2024
Track Document
ASTM A625/A625M-13(2018)
Standard Specification for Tin Mill Products, Black Plate, Single-Reduced
Standard Specification for Tin Mill Products, Black Plate, Single-Reduced
A0625_A0625M-13R18
ASTM|A0625_A0625M-13R18|en-US
Standard Specification for Tin Mill Products, Black Plate, Single-Reduced
Standard
A625/A625M Standard Specification for Tin Mill Products, Black Plate, Single-Reduced>
new
BOS Vol. 01.06 Committee A01
$
77.00
In stock
ASTM International
Abstract
This specification covers single-reduced black plate produced from low carbon, cold-reduced steel, furnished in coils and cut sizes, for use in the manufacture of containers, closures, signs, toys and other products, as well as for plating applications. The black plates shall be produced with ground roll and shot-blasted roll finishes and shall be furnished oiled or dry.
Scope
1.1 This specification covers single-reduced black plate produced from low carbon, cold-reduced steel, furnished in coils and cut sizes, for use in the manufacture of containers, closures, signs, toys and other products, as well as for plating applications.
1.2 It may be supplied dry or oiled and with or without surface treatment. This product is normally supplied with a trimmed edge.
1.3 This specification is applicable to orders in either inch-pound units (as A625), which is supplied in thicknesses from 135-lb base weight (0.0149 in.) and lighter, or SI units (as A625M), which is supplied in thicknesses from 0.378 mm and lighter.
1.4 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.