Standard
Historical
Last Updated: Oct 16, 2013
Track Document
ASTM A624/A624M-03(2008)e1
Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
A0624_A0624M-03R08E01
ASTM|A0624_A0624M-03R08E01|en-US
Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
Standard
A624/A624M Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced>
new
BOS Vol. 01.06 Committee A01
$
86.00
In stock
Abstract
This specification covers single-reduced electrolytic tin plate produced from low-carbon cold-reduced steel furnished in coils and cut sizes for use in the manufacture of cans, closures, crowns, and other products. The material shall conform to the coating weight [mass] test values. Details on standard heavy marking system for differential electrolytic tin plate shall be described. Standard light side marking system for differential electrolytic tin plate shall also be indicated. Chemical treatments such as cathodic sodium dichromate treatment and sodium dichromate dip treatment shall be applied after the tin coating has been deposited and immediately preceding the oiling, to control tin oxide formation and growth.
Scope
1.1 This specification covers single-reduced electrolytic tin plate produced from low-carbon cold-reduced steel furnished in coils and cut sizes for use in the manufacture of cans, closures, crowns, and other products. It is furnished in commercially available tin coating weights [masses], and is normally supplied with a trimmed edge.
1.2 This specification is applicable to orders in either inch-pound units (as A 624) which is supplied in nominal thicknesses from 0.0061 to 0.0149 in. or SI units [as A 624M] which is supplied in nominal thicknesses from 0.155 to 0.378 mm.
1.3 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.