Standard
Active
Last Updated: Sep 06, 2022
Track Document
ASTM A355-89(2022)
Standard Specification for Steel Bars, Alloys, for Nitriding
Standard Specification for Steel Bars, Alloys, for Nitriding
A0355-89R22
ASTM|A0355-89R22|en-US
Standard Specification for Steel Bars, Alloys, for Nitriding
Standard
A355 Standard Specification for Steel Bars, Alloys, for Nitriding>
new
BOS Vol. 01.05 Committee A01
$
64.00
In stock
Abstract
This specification covers standard specification for alloy steel bars, suitable for surface hardening by nitriding, designated as Classes A, B, C, and D. Class A and Class D bars are general-purpose bars; Class B bars are free-machining bars; Class C bars contain nickel and are characterized by higher core strength. All classes shall be furnished in the hot-rolled, quenched, and tempered condition. The steel shall be made by the electric-furnace process only. The microstructure resulting from heat treatment shall not show free ferrite in amounts exceeding the prescribed values. The maximum depth of total and partial decarburization of hot-rolled bars and heat-treated bars shall not exceed the amounts prescribed. Heat or cast analysis shall be performed on four classes of steel, wherein the material shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, chromium, aluminum, molybdenum, selenium, and nickel. After quenching and tempering, the steel shall conform to one of the specified hardness ranges.
Scope
1.1 This specification covers alloy steel bars, suitable for surface hardening by nitriding, designated as Classes A, B, C, and D. Class A and Class D bars are general-purpose bars; Class B bars are free-machining bars; Class C bars contain 3.50 % nickel and are characterized by higher core strength. All classes are normally furnished in the hot-rolled, quenched, and tempered condition. However, centerless-ground or turned bars, in any of the classes, may be specified by the purchaser. Also, as-rolled, annealed, or unannealed bars suitable for forging may be purchased to this specification. When as-rolled, annealed, or unannealed bars are furnished, Sections 6, 10, and 11 are not applicable.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.