Standard
Historical
Last Updated: Jul 21, 2017
Track Document
ASTM A247-16a
Standard Test Method for Evaluating the Microstructure of Graphite in Iron Castings
Standard Test Method for Evaluating the Microstructure of Graphite in Iron Castings
A0247-16A
ASTM|A0247-16A|en-US
Standard Test Method for Evaluating the Microstructure of Graphite in Iron Castings
Standard
A247 Standard Test Method for Evaluating the Microstructure of Graphite in Iron Castings>
new
BOS Vol. 01.02 Committee A04
$
96.00
In stock
Significance and Use
4.1 The comparison of observed graphite particles with the structures shown in the charts give only purely descriptive information on the type, distribution, and size of the graphite in the sample being evaluated. It does not indicate, except in a very broad way, the origin of the graphite or the suitability of the iron-carbon alloy for a particular service.
Scope
1.1 This test method covers the classification of graphite in cast irons in terms of type, distribution, and size by visual comparison to reference photomicrographs. This test method is intended to be applicable for all iron-carbon alloys containing graphite particles, and may be applied to gray irons, malleable irons, compacted graphite irons, and the ductile (nodular) irons.
1.2 The reference photomicrographs included in this test method are in no way to be construed as specifications. In an appropriate specification for a specific material where graphite microstructure is an important consideration, this test method may be used as a reference to define concisely the graphite microstructure required.
1.3 These reference photomicrographs are offered primarily to permit accurate reporting of microstructures of cast irons and to facilitate the comparison of reports by different laboratories or investigators.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.