Standard
Active
Last Updated: Aug 15, 2018
Track Document
ASTM D2252-18
Standard Specification for Fineness of Types of Alpaca
Standard Specification for Fineness of Types of Alpaca
D2252-18
ASTM|D2252-18|en-US
Standard Specification for Fineness of Types of Alpaca
Standard
D2252 Standard Specification for Fineness of Types of Alpaca>
new
BOS Vol. 07.01 Committee D13
$
64.00
In stock
Significance and Use
4.1 This specification for fineness is intended as a guide for production, preparation, and marketing (Note 1) by comparing the average fiber diameter of a measured specimen with the fineness specifications for the various types listed in Table 1. The standard deviation which expresses measured variability of a specimen may be compared with the average shown in Table X2.1.
Note 1: Test Method D2130 does not include any values for the precision to be expected in the testing of alpaca fibers. In an interlaboratory test in which six laboratories each made one test on each of six type samples, HTB-CB, HAXB-CB, HAAB-CB, HAB-CB, HLPB-CL, and HSKB-CL, the coefficient of variation of the average fiber diameters between laboratories, including test variation, was 3.2, 4.7, 3.8, 4.5, 2.2, and 0.93 % for the respective alpaca types.
Abstract
This specification is applicable in the classification of alpaca into types according to fineness. Five types of alpaca have been classified according to its average diameter limit, namely Type T Extra, Type T, Type X, Type AA, Type A, Type SK, and Type LP.
Scope
1.1 This specification is applicable in the classification of alpaca into types according to fineness.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.