Standard
Active
Last Updated: May 26, 2025
Track Document
ASTM G92-20(2025)
Standard Practice for Characterization of Atmospheric Test Sites
Standard Practice for Characterization of Atmospheric Test Sites
G0092-20R25
ASTM|G0092-20R25|en-US
Standard Practice for Characterization of Atmospheric Test Sites
Standard
G92 Standard Practice for Characterization of Atmospheric Test Sites>
new
BOS Vol. 03.02 Committee G01
$
72.00
In stock
ASTM International
Significance and Use
4.1 This practice gives suggested procedures for characterization of atmospheric test sites. It can be useful to researchers, manufacturers, engineering firms, architects, and construction contractors to provide corrosion and environmental data, materials selection information, and a materials storage practice.
4.2 This practice does not give specific parameters for classifying the type of test site.
Scope
1.1 This practice covers procedures for the characterization of atmospheric test sites. Continuous characterization can provide corrosion data, environmental data, or both which will signal changes in corrosivity of the atmospheric environment. This practice can also provide guidance for classification of future test sites.
1.2 Two methods are defined in this practice for the characterization of atmospheric test sites. The methods are identified as characterization Methods A and B. The preferred characterization technique would require using both Method A and B for concurrent data collection.
1.2.1 Method A is to be used when atmospheric corrosion is monitored on a continuing basis at a test site using specified materials and exposure configurations.
1.2.2 Method B is specified when atmospheric factors are monitored on a continuing basis.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.