Standard
Active
Last Updated: Jun 10, 2025
Track Document
ASTM G1-25
Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
G0001-25
ASTM|G0001-25|en-US
Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
Standard
G1 Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens>
new
BOS Vol. 03.02 Committee G01
$
72.00
In stock
ASTM International
Significance and Use
4.1 The procedures given are designed to remove corrosion products without significant removal of base metal. This allows an accurate determination of the mass loss of the metal or alloy that occurred during exposure to the corrosive environment.
4.2 These procedures, in some cases, may apply to metal coatings. However, possible effects from the substrate must be considered.
Scope
1.1 This practice covers suggested procedures for preparing bare, solid metal specimens for tests, for removing corrosion products after the test has been completed, and for evaluating the corrosion damage that has occurred. Emphasis is placed on procedures related to the evaluation of corrosion by mass loss and pitting measurements. (Warning—In many cases the corrosion product on the reactive metals titanium and zirconium is a hard and tightly bonded oxide that defies removal by chemical or ordinary mechanical means. In many such cases, corrosion rates are established by mass gain rather than mass loss.)
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 1.1 and 7.2.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.