Standard
Active
Last Updated: Sep 18, 2020
Track Document
ASTM F3358-20
Standard Practice for Labeling and Information for Exoskeletons
Standard Practice for Labeling and Information for Exoskeletons
F3358-20
ASTM|F3358-20|en-US
Standard Practice for Labeling and Information for Exoskeletons
Standard
F3358 Standard Practice for Labeling and Information for Exoskeletons>
new
BOS Vol. 15.13 Committee F48
$
64.00
In stock
Significance and Use
4.1 This practice contains the recommendations for minimal informational requirements for the identification of exoskeletons. It is intended to provide the user with some of the basic information necessary for the selection and use of the exoskeletons.
4.2 Additional information beyond the content recommended by this practice is permitted to be applied to the label.
Scope
1.1 This practice sets forth labeling and instruction guidelines for manufacturers of exoskeletons.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.