Standard
Active
Last Updated: Mar 09, 2021
Track Document
ASTM ISO/ASTM52903-1-20
Additive manufacturing — Material extrusion-based additive manufacturing of plastic materials — Part 1: Feedstock materials
Additive manufacturing — Material extrusion-based additive manufacturing of plastic materials — Part 1: Feedstock materials
F3241-20
ASTM|F3241-20|en-US
Additive manufacturing — Material extrusion-based additive manufacturing of plastic materials — Part 1: Feedstock materials
Standard
ISO/ASTM52903-1 Additive manufacturing — Material extrusion-based additive manufacturing of plastic materials — Part 1: Feedstock materials>
new
BOS Vol. 10.04 Committee F42
$
44.00
In stock
Scope
1.1 This document describes a method for defining requirements for plastic materials used in extrusion-based additive manufacturing (AM) processes. Materials include unfilled, filled, and reinforced plastic materials suitable for processing into parts. These materials can also contain special additives (e.g., flame retardants, stabilizers, etc.). Processes include all material extrusion-based AM processes.
This document is intended for use by manufacturers of materials, feedstocks, or plastic parts or any combination of the three using material extrusion-based AM.
Note 1: In some cases, material manufacturers can also be feedstock manufacturers. In other cases, a material manufacturer can supply materials (example: pellets) to a feedstock manufacturer (example: convertor of pellets into filaments).
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.