Standard
Active
Last Updated: Apr 03, 2024
Track Document
ASTM F2822-10(2024)
Standard Specification for Fixed Anchorages Installed on Structures Used for Rope Rescue Training
Standard Specification for Fixed Anchorages Installed on Structures Used for Rope Rescue Training
F2822-10R24
ASTM|F2822-10R24|en-US
Standard Specification for Fixed Anchorages Installed on Structures Used for Rope Rescue Training
Standard
F2822 Standard Specification for Fixed Anchorages Installed on Structures Used for Rope Rescue Training>
new
BOS Vol. 13.02 Committee F32
$
64.00
In stock
ASTM International
Abstract
This specification specifies the minimum strength requirements for anchorages permanently installed or attached to training towers or other structures used for rope rescue training. It specifies the design loads that must be considered and does not describe how those anchorages are constructed, installed in, or attached to the structure nor does it include any factors of safety. Each anchorage shall be designed to hold a minimum of 40 kN in all directions of potential loading and shall be manufactured in such a way that a carabiner with a gate opening of 25 mm or greater shall fit around it and the gate shall be able to close and lock. The anchorage shall be constructed using rounded stock or with beveled or chamfered edges to minimize damage to hardware, rope, or webbing that is attached to the anchorage.
Scope
1.1 This standard specifies the minimum strength requirements for anchorages permanently installed or attached to training towers or other structures used for rope rescue training. It does not describe how those anchorages are constructed, installed in, or attached to the structure, nor does it include any factors of safety. It only specifies the design loads that must be considered.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.