There is no PDF download available at this time. Please contact customer service.
Standard
Withdrawn, No replacement
Last Updated: Jan 14, 2020
Track Document
ASTM F2497-05(2011)e1
Standard Practice for Abrasion and Scuff Resistance of Inkjet Media by the Sutherland Rub Tester (Withdrawn 2020)
Standard Practice for Abrasion and Scuff Resistance of Inkjet Media by the Sutherland Rub Tester (Withdrawn 2020)
F2497-05R11E01
ASTM|F2497-05R11E01|en-US
Standard Practice for Abrasion and Scuff Resistance of Inkjet Media by the Sutherland Rub Tester (Withdrawn 2020)
Standard
F2497 Standard Practice for Abrasion and Scuff Resistance of Inkjet Media by the Sutherland Rub Tester (Withdrawn 2020)>
new
BOS Vol. 15.11 Committee F05
$
0.00
Out of stock
Significance and Use
Abrasion resistance is a desirable and sometimes critical property of printed materials. Abrasion damage can occur during shipment, storage, handling, and end use. The result is a significant decrease in product appearance and legibility of product information. The amount of abrasion damage to a printed substrate is dependent on shipping conditions, possibly temperature and humidity, time, and many other variables. This practice provides a way of comparing abrasion resistance of printed materials under laboratory conditions.
This practice also can be used to evaluate the relative abrasion and scuff resistance of printed and unprinted inkjet media.
This practice can provide a reasonably simple procedure that can be used by both the buyer and the seller of printed materials to determine if the product offered for sale meets some predetermined standard for abrasion or scuff resistance.
Scope
1.1 This practice covers a procedure for determining the abrasion resistance of printed and unprinted inkjet media using the Sutherland Rub Tester, or its equivalent, equipped with full-width rubber pads and using standardized receptors.
1.2 This practice is applicable to printed and unprinted inkjet media.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.