Standard
Historical
Last Updated: Feb 07, 2024
Track Document
ASTM F2440-18
Standard Specification for Indoor Wall/Feature Padding
Standard Specification for Indoor Wall/Feature Padding
F2440-18
ASTM|F2440-18|en-US
Standard Specification for Indoor Wall/Feature Padding
Standard
F2440 Standard Specification for Indoor Wall/Feature Padding>
new
BOS Vol. 15.07 Committee F08
$
77.00
In stock
ASTM International
Significance and Use
5.1 The padding shall be constructed to yield the values listed in Table 1 throughout the impact area under the conditions of the manufacturer's warranty.
(A) As specified by manufacturer
5.2 Special requirements for the padding shall be subject to purchase agreements. Special requirements shall never reduce any of the basic requirements listed in this standard.
5.3 Good manufacturing practices shall be used in the construction and inspection of the padding.
Abstract
This specification covers wall padding and padding for other indoor structures. All padding constructions are included. Qualification of construction designs and comparison of products shall be discussed. The padding can be classified into two types: Type 1 for permanently attached paddings and Type 2 for removable paddings. The paddings can also be classified into grades: Grade A for coated paddings and Grade B for covered or encased paddings. Physical properties such as shock absorption, gmax, HIC, and thickness shall be determined.
Scope
1.1 This specification covers wall padding and padding for other indoor structures. All padding constructions are included. The intended use of this specification is for the qualification of construction designs and comparison of products.
Note 1: This specification was developed due to the numerous designs in existence and the need to provide a method to determine if a wall pad meets a minimum level of protection.
Note 2: There is no equivalent ISO standard.
1.2 The values as stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 7.1 for specific hazards statement.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.