Standard
Historical
Last Updated: Apr 25, 2022
Track Document
ASTM F2435-15
Standard Specification for Steel Reinforced Polyethylene (PE) Corrugated Pipe
Standard Specification for Steel Reinforced Polyethylene (PE) Corrugated Pipe
F2435-15
ASTM|F2435-15|en-US
Standard Specification for Steel Reinforced Polyethylene (PE) Corrugated Pipe
Standard
F2435 Standard Specification for Steel Reinforced Polyethylene (PE) Corrugated Pipe>
new
BOS Vol. 08.04 Committee F17
$
72.00
In stock
Significance and Use
4.1 Steel reinforced corrugated PE pipes are used for underground applications where soil provides support to their flexible walls. Their major use is to collect or convey storm water run-off for sewers and drains, or both.
4.2 Exclusions from recommended use:
4.2.1 Permanent exposure to sunlight and exposure to chemicals whose compatibility with the pipe and fittings is not known.
Abstract
This specification covers requirements and test methods for materials, dimensions, workmanship, elongation, impact resistance, pipe stiffness, perforations, and markings for steel reinforced corrugated polyethylene (PE) piping systems. The steel reinforced polyethylene pipes governed by this standard are intended for use in underground applications where soil provides support for their flexible walls. These pipes will be used to collect or convey storm-water runoff for storm sewers and drainage pipes, or both. The following tests shall be performed: pipe dimensions and tolerances; perforations; pipe stiffness; steel to the polyethylene bonding; and joint tightness.
Scope
1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, elongation, impact resistance, pipe stiffness, perforations, and markings for steel reinforced corrugated polyethylene (PE) piping systems of nominal sizes 8 in. (200 mm), through 80 in. (2000 mm). The steel reinforced polyethylene pipes governed by this standard are intended for use in underground applications where soil provides support for their flexible walls. The steel reinforced polyethylene corrugated pipes governed by this standard are intended for use in non-pressure applications for sanitary sewers, storm sewers and drainage pipes.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 There is no similar or equivalent ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.