Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM F1899-98(2003)
Standard Specification for Food Waste Pulper Without Waterpress Assembly
Standard Specification for Food Waste Pulper Without Waterpress Assembly
F1899-98R03
ASTM|F1899-98R03|en-US
Standard Specification for Food Waste Pulper Without Waterpress Assembly
Standard
F1899 Standard Specification for Food Waste Pulper Without Waterpress Assembly>
new
BOS Vol. 15.12 Committee F26
$
77.00
In stock
Abstract
This specification covers pulper assemblies intended for grinding of food scraps and limited amounts of cardboard, paper, and disposable plastic food service wear. Pulper assemblies shall be of the following types: Type A and Type B. Lubricating points shall be readily accessible, and the pulper shall be lubricated with the proper amount of lubricant prior to delivery. All surfaces of the machine, other than corrosion-resistant materials, shall be protected against corrosion in the use environment and shall present a neat appearance. Test method shall be performed to demonstrate the ability of the unit to meet the capacity requirements and to insure that there is no leakage during operation.
Scope
1.1 This specification covers pulper assemblies intended for grinding of food scraps and limited amounts of cardboard, paper, and disposable plastic food service wear.
1.2 The values as stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are provided for information only.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 13, of this specification:
1.4 This standard does not purport to address all of the safety concerns, if, any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.