Standard
Active
Last Updated: May 30, 2025
Track Document
ASTM F1885-25
Standard Guide for Irradiation of Dried Spices, Herbs, Vegetable Seasonings, and Plant Materials Used in the Production of Dietary Substances to Control Pathogens and Other Microorganisms
Standard Guide for Irradiation of Dried Spices, Herbs, Vegetable Seasonings, and Plant Materials Used in the Production of Dietary Substances to Control Pathogens and Other Microorganisms
F1885-25
ASTM|F1885-25|en-US
Standard Guide for Irradiation of Dried Spices, Herbs, Vegetable Seasonings, and Plant Materials Used in the Production of Dietary Substances to Control Pathogens and Other Microorganisms
Standard
F1885 Standard Guide for Irradiation of Dried Spices, Herbs, Vegetable Seasonings, and Plant Materials Used in the Production of Dietary Substances to Control Pathogens and Other Microorganisms>
new
BOS Vol. 12.02 Committee E61
$
72.00
In stock
ASTM International
Significance and Use
4.1 The purpose of irradiation of dried plant materials used for spices, herbs, vegetable seasonings, and dietary substances is to control pathogenic bacteria, molds, and yeasts present in these commodities (2-7).
4.2 The process will also kill any insects present, at all stages of development.
Note 2: CAC/RCP 19-1979 of the Codex Alimentarius identifies the essential practices to be implemented to achieve effective radiation processing of food, in general, in a manner that maintains quality and yields food commodities that are safe and suitable for consumption.
Scope
1.1 This guide covers procedures for irradiation of dried plant materials used in the production of spices, herbs, vegetable seasonings, and dietary substances for microbiological control. Generally, these items have moisture content of 4.5 to 12 % and are available in whole, ground, chopped, or other finely divided forms, or as blends. The blends may contain sodium chloride and minor amounts of dry food materials ordinarily used in such blends.
1.2 This guide covers gamma, electron beam, and X-radiation treatment. This guide also covers low-energy electron beam treatment where only part of the product is irradiated (that is, surface treatment).
1.3 This guide covers absorbed doses ranging from 3 to 30 kilogray (kGy).
Note 1: U.S. regulations permit a maximum dose of 30 kGy. (See 21 CFR 179.26.) EU regulations permit a maximum dose of 10 kGy. (See Directive 1999/3/EC.)
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This document is one of a set of standards that provides recommendations for properly implementing and utilizing radiation processing. It is intended to be read in conjunction with ASTM Practice 52628.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.