Standard
Active
Last Updated: Dec 16, 2025
Track Document
ASTM F468M-06(2025)
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
F0468M-06R25
ASTM|F0468M-06R25|en-US
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Standard
F468M Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)>
new
BOS Vol. 01.09 Committee F16
$
72.00
In stock
ASTM International
Significance and Use
13.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.
Abstract
This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs manufactured from a number of alloys in common use and intended for general service applications. The bolts, cap screws, and studs shall be manufactured from material having a chemical composition conforming to the requirements specified. The fasteners shall be cold formed, hot formed, or machined from suitable material. Different tests shall be conducted in order to determine the following mechanical properties of fasteners: hardness, tensile strength, yield strength, and elongation.
Scope
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.
1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1: This specification is the metric companion of Specification F468.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.