Standard
Active
Last Updated: Jul 29, 2024
Track Document
ASTM F68-16(2024)
Standard Specification for Oxygen-Free Copper in Wrought Forms for Electron Devices
Standard Specification for Oxygen-Free Copper in Wrought Forms for Electron Devices
F0068-16R24
ASTM|F0068-16R24|en-US
Standard Specification for Oxygen-Free Copper in Wrought Forms for Electron Devices
Standard
F68 Standard Specification for Oxygen-Free Copper in Wrought Forms for Electron Devices>
new
BOS Vol. 02.01 Committee B05
$
72.00
In stock
ASTM International
Abstract
This specification establishes the requirements for wrought forms and fabricated shapes of oxygen-free copper with UNS No. C10100 suitable for use in electron devices. Specimens shall be appropriately sampled and shall undergo hydrogen embrittlement (reverse bend) test, special macro examination, and special microscopical examination. Materials shall adhere to specified mechanical, dimensional, chemical composition, electrical resistivity, and grain size requirements.
Scope
1.1 This specification establishes the requirements for wrought and fabricated shapes made from Copper UNS2 No. C10100, conforming to the chemical requirements of Specification B170, Grade 1, and suitable for use in electron devices.
1.2 The requirements of this specification are in addition to those prescribed in the following product specifications appropriate to the material being ordered: B1, B2, B3, B75/B75M, B152/B152M, B170, B187/B187M, B188, B272, and B372. In case of conflict, however, this specification shall take precedence.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3.1 Exception—grain sizes are in metric units and are standard.
1.4 The following safety hazard caveat applies to sections 17.4, 17.5 and 18.7 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.