There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
Standard
Withdrawn, No replacement
Last Updated: Nov 30, 2023
Track Document
ASTM F44-21
Standard Specification for Metallized Surfaces on Ceramic (Withdrawn 2023)
Standard Specification for Metallized Surfaces on Ceramic (Withdrawn 2023)
F0044-21
ASTM|F0044-21|en-US
Standard Specification for Metallized Surfaces on Ceramic (Withdrawn 2023)
Standard
F44 Standard Specification for Metallized Surfaces on Ceramic (Withdrawn 2023)>
new
BOS Vol. 10.04 Committee F01
$
0.00
Out of stock
ASTM International
Abstract
This specification covers requirements for powdered refractory metal coatings produced with or without additives. These coatings are applied to ceramic bodies in order to join ceramic bodies to metals or to other metallized ceramics by means of brazing or soldering. Included in this specification are requirements for a secondary metallic layer which is usually applied over the refractory metal layer. Two levels of quality for uniformity of metallizing are discussed, Level A and Level B. These levels discuss conditions and requirements needed in order to accept the uniformity of metallizing. Thickness of metallizing shall be measured using a metallurgical microscope. A polished cross-section that is perpendicular to the metallized surfaced is measured. The particles in the metallized layer must be sintered in order to form a dense matrix when viewed in cross section at 400 times. This cross section will indicate the extent of threedimensional sintering. A torque peel test and a tension test shall be performed in order to determine the bond strength of brazed metallized ceramics. Vacuum tightness of the brazed metallized ceramics shall also be determined.
Scope
1.1 This specification covers requirements for powdered refractory metal coatings produced with or without additives. These coatings are applied to ceramic bodies to join ceramic bodies to metals or to other metallized ceramics by means of brazing or soldering. Included in this specification are requirements for a secondary metallic layer which is usually applied over the refractory metal layer.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.