There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
Standard
Withdrawn, No replacement
Last Updated: Nov 28, 2023
Track Document
ASTM F7-95(2021)
Standard Specification for Aluminum Oxide Powder (Withdrawn 2023)
Standard Specification for Aluminum Oxide Powder (Withdrawn 2023)
F0007-95R21
ASTM|F0007-95R21|en-US
Standard Specification for Aluminum Oxide Powder (Withdrawn 2023)
Standard
F7 Standard Specification for Aluminum Oxide Powder (Withdrawn 2023)>
new
BOS Vol. 10.04 Committee F01
$
0.00
Out of stock
ASTM International
Abstract
This specification covers aluminum oxide (alumina) powder in two classes of particle size, two chemical grades, and two levels of acidity. Aluminum oxide powder shall conform to the chemical composition requirements indicated in this specification. The alumina powder shall be tested for water-soluble content, particle size, and hydrogen-ion concentration according to the procedures in this specification.
Scope
1.1 This specification covers aluminum oxide (alumina) powder in two classes of particle size, two chemical grades, and two levels of acidity, for use as an insulating coating or as an ingredient of ceramic mixtures for components of electronic devices as follows:
1.1.1 Particle Sizes:
1.1.1.1 Class A—Particle size No. 500 nominal mesh (nominal average particle size = 24.3 μm).
1.1.1.2 Class B—Particle size No. 900 nominal mesh (nominal average particle size = 1.7 μm).
1.1.2 Chemical Grades—Grades 1 and 2 as specified under chemical requirements in Section 3.
1.1.3 Acidity Levels: pH (acid) 4.5 to 6.5 and pH (neutral) 6.5 to 7.5.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following safety hazards caveat pertains only to the test methods in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.