Standard
Historical
Last Updated: Jan 06, 2022
Track Document
ASTM E3050-16
Standard Specification for Denatured Ethanol for Use as Cooking and Appliance Fuel
Standard Specification for Denatured Ethanol for Use as Cooking and Appliance Fuel
E3050-16
ASTM|E3050-16|en-US
Standard Specification for Denatured Ethanol for Use as Cooking and Appliance Fuel
Standard
E3050 Standard Specification for Denatured Ethanol for Use as Cooking and Appliance Fuel>
new
BOS Vol. 05.06 Committee E48
$
77.00
In stock
Abstract
This specification provides requirements and corresponding test methods for denatured ethanol intended to be used as a cooking or appliance fuel, or both. The addition of a denatonium benzoate and a colored dye is required. The minimum and maximum requirements for the amount in which denatonium benzoate must be added are specified. The hydrocarbons approved for use under this specification are gasoline, unleaded gasoline, natural gasoline, heptane, or rubber hydrocarbon solvent.
Also addressed in this specification are workmanship, sampling, sontainers, and sample handling. The test methods cover ethanol, water, and higher alcohols as well as acidity and solvent-washed gum content.
Scope
1.1 This specification covers denatured ethanol intended to be used as a cooking or appliance fuel, or both.
1.2 Nothing in this specification shall preclude observance of federal, state, or local regulations.
1.2.1 Denatured ethanol has many regulatory limitations that cover the production, trading, transporting, distributing, wholesale and retail sale, and use of denatured ethanol; this specification does not purport to address the regulatory compliance aspects of these activities.
1.3 The addition of a denatonium benzoate is required in addition to any other denaturants that are added.
1.3.1 The denatonium benzoate is added as an additional deterrent to consumption. The denatonium benzoate must be added in an amount that meets the minimum and maximum requirements listed in Table 1.
1.4 The addition of a colored dye is also required. The colored dye must be added in a concentration sufficient to enable the visual detection of the color in the fuel but in an amount less than the maximum listed in Table 1.
1.4.1 The colored dye is added to visually indicate that the product is not potable.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.