Standard
Active
Last Updated: Apr 14, 2021
Track Document
ASTM E2071-21
Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
E2071-21
ASTM|E2071-21|en-US
Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
Standard
E2071 Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data>
new
BOS Vol. 14.01 Committee E37
$
64.00
In stock
Abstract
This practice describes the calculation of the heat of vaporization of a liquid or the heat of sublimation of a solid from measured vapor pressure data. It is applicable to pure liquids, azeotropes, pure solids, and homogenous solid solutions over the temperature range for which the vapor pressure equation fitted to the measured data is applicable. Vapor pressure data shall be measured in accordance to the test methods and shall be correlated with the Antoine equation. The heat of vaporization or sublimation is computed at the desired temperature from the vapor-pressure temperature derivative from the fitted Antoine equation by use of the Clapeyron equation.
Scope
1.1 This practice describes the calculation of the heat of vaporization of a liquid or the heat of sublimation of a solid from measured vapor pressure data. It is applicable to pure liquids, azeotropes, pure solids, and homogenous solid solutions over the temperature range for which the vapor pressure equation fitted to the measured data is applicable.
Note 1: This practice is generally not applicable to liquid mixtures. For a pure liquid or azeotrope, composition does not change upon vaporization so that the integral heat of vaporization is identical to the differential heat of vaporization. Non-azeotropic liquid mixtures change composition upon vaporizing. Heat of vaporization data computed from this practice for a liquid mixture are valid only as an approximation to the mixture differential heat of vaporization; it is not a valid approximation to the mixture integral heat of vaporization.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.