Standard
Active
Last Updated: Jul 15, 2025
Track Document
ASTM E2040-25
Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers
Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers
E2040-25
ASTM|E2040-25|en-US
Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers
Standard
E2040 Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers>
new
BOS Vol. 14.01 Committee E37
$
64.00
In stock
ASTM International
Significance and Use
5.1 This test method calibrates or demonstrates conformity of thermogravimetric apparatus at ambient conditions. Most thermogravimetry analysis experiments are carried out under increasing temperature conditions or at isothermal temperatures distant from ambient conditions. This test method does not address the temperature effects on mass calibration.
5.2 In most thermogravimetry experiments, the mass change is reported as weight percent in which the observed mass at any time during the course of the experiment is divided by the original mass of the test specimen. This method of reporting results assumes that the mass scale of the apparatus is linear with increasing mass. In such cases, it may be necessary only to confirm the performance of the instrument by comparison to a suitable reference.
5.3 When the actual mass of the test specimen is recorded, the use of a calibration factor to correct the calibration of the apparatus may be required, on rare occasions.
Scope
1.1 This test method describes the calibration or performance confirmation of the mass (or weight) scale of thermogravimetric analyzers and is applicable to commercial and custom-built apparatus.
1.2 The SI units are the standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.