Standard
Active
Last Updated: Jul 21, 2025
Track Document
ASTM E1731-25
Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves
Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves
E1731-25
ASTM|E1731-25|en-US
Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves
Standard
E1731 Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves>
new
BOS Vol. 15.03 Committee E21
$
72.00
In stock
ASTM International
Significance and Use
5.1 The NVR obtained by this test method is that amount which is available for release by the gloves onto handled surfaces while cleaning surfaces with solvents.
5.2 Evaporation of solvent at the stated temperature is to quantify the NVR that can be expected to exist at room temperature, since the slight difference between room temperature and the test temperature is not likely to result in significant variances.
5.3 This method may be more aggressive than necessary to determine the suitability of cleanroom gloves that are restricted to dry operations only.
5.4 Various other methods exist for determining NVR, for example Practice G120 and IEST-RP-CC005. This test is not intended to replace test methods used for other purposes.
Scope
1.1 This test method covers the determination of solvent extractable nonvolatile residue (NVR) from gloves used in cleanrooms where spacecraft are assembled, cleaned, or tested.
1.2 The NVR of interest is that which can be extracted from gloves using a specified solvent that has been selected for its extracting qualities, or because it is representative of solvents used in the particular facility. Alternative solvents may be used, but since their use may result in different values being generated, they must be identified in the procedure data sheet.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.