Standard
Historical
Last Updated: May 13, 2016
Track Document
ASTM E1615-08
Standard Test Method for Iron in Trace Quantities Using the FerroZine Method
Standard Test Method for Iron in Trace Quantities Using the FerroZine Method
E1615-08
ASTM|E1615-08|en-US
Standard Test Method for Iron in Trace Quantities Using the FerroZine Method
Standard
E1615 Standard Test Method for Iron in Trace Quantities Using the FerroZine Method>
new
BOS Vol. 06.04 Committee E15
$
77.00
In stock
Significance and Use
This test method is suitable for determining trace concentrations of iron in a wide variety of products, provided that appropriate sample preparation has rendered the iron and sample matrix soluble in water or other suitable solvent. Each sample matrix must be investigated for suitability using this test method.
This test method assumes that the amount of color developed is proportional to the amount of iron in the test solution. The calibration curve is linear over the specified range.
Scope
1.1 This test method covers the determination of iron in the range from 0.01 to 0.2 μg/g using FerroZine reagent solution. The range may be extended through the use of a 5- or 10-cm cell or by suitable dilution of the sample solution.
1.2 This test method is intended to be general for the final steps in the determination of iron and does not include procedures for sample preparation.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 Review the current material safety data sheets (MSDS) for detailed information concerning toxicity, first-aid procedures, and safety precautions.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 7.4.