Standard
Active
Last Updated: Oct 06, 2022
Track Document
ASTM E754-80(2022)
Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints
Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints
E0754-80R22
ASTM|E0754-80R22|en-US
Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints
Standard
E754 Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints>
new
BOS Vol. 04.11 Committee E06
$
72.00
In stock
ASTM International
Significance and Use
5.1 This test method is intended to provide a simple inexpensive means of generating conservative, comparative data on pullout strengths of various ties and anchors used with different types of masonry units and mortars. This test method is recommended for such use until economical, improved methods can be developed to simulate service conditions more inclusively.
Scope
1.1 This test method provides procedures for determining the ability of individual masonry ties and anchors to resist extraction from a masonry mortar joint.
1.2 Two laboratory testing procedures are provided for use with test specimens which consist of a masonry tie or anchor embedded in mortar between twin stack-bonded masonry units.
1.2.1 Procedure A—For use with small (brick-size) masonry units.
1.2.2 Procedure B—For use with large (block-size) masonry units.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.