There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
Standard
Withdrawn, No replacement
Last Updated: Dec 31, 2010
Track Document
ASTM E234-98(2003)e1
Standard Test Method for Total Bromine Number of Unsaturated Aliphatic Chemicals (Withdrawn 2008)
Standard Test Method for Total Bromine Number of Unsaturated Aliphatic Chemicals (Withdrawn 2008)
E0234-98R03E01
ASTM|E0234-98R03E01|en-US
Standard Test Method for Total Bromine Number of Unsaturated Aliphatic Chemicals (Withdrawn 2008)
Standard
E234 Standard Test Method for Total Bromine Number of Unsaturated Aliphatic Chemicals (Withdrawn 2008)>
new
BOS Vol. 06.04 Committee E15
$
0.00
Out of stock
Significance and Use
This test method is a good general means for measuring ethylenic (double-bond) unsaturation and is applicable to many compounds because of its speed, convenience, and minimum tendency for substitution. This test method has been applied to alpha-olefins, cyclic unsaturated hydrocarbons such as the cyclopentenes, unsaturated aliphatic side chains on aromatic rings, unsaturated esters and alcohols, acrylic and methyacrylic esters, acids, and salts, and other similar compounds. Diisobutylene and some tertiary-substituted hydrocarbons substitute to some extent but probably less by this test method than by most others. It is not satisfactory for such materials as commercial propylene trimer and tetramer, butene dimer, and mixed nonenes, octenes, and heptenes. For the bromine number of petroleum distillates that are substantially free of material lighter than isobutane and that have 90 % distillation points under 620°F (327°C) (such as gasoline), Test Method D 1159
Scope
1.1 This test method covers the determination of total bromine number in various double-bonded aliphatic compounds, using pyridine sulfate dibromide (PSDB), also known as Rosenmund-Kuhnhenn reagent. The total unsaturation is determined, whether conjugated or not.
1.2 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7 and in paragraphs 5.1.1, 6.4.1, 6.7.1, and 8.1.