Standard
Active
Last Updated: Mar 12, 2024
Track Document
ASTM D8544-24
Standard Test Method for Determination of Conductive Deposits of Electrical and Mechanical Components from Fluids in Liquid and Vapor States within an Electrically Charged System
Standard Test Method for Determination of Conductive Deposits of Electrical and Mechanical Components from Fluids in Liquid and Vapor States within an Electrically Charged System
D8544-24
ASTM|D8544-24|en-US
Standard Test Method for Determination of Conductive Deposits of Electrical and Mechanical Components from Fluids in Liquid and Vapor States within an Electrically Charged System
Standard
D8544 Standard Test Method for Determination of Conductive Deposits of Electrical and Mechanical Components from Fluids in Liquid and Vapor States within an Electrically Charged System>
new
BOS Vol. 05.05 Committee D02
$
72.00
In stock
ASTM International
Significance and Use
5.1 This method may be utilized to assess the suitability of a fluid for use in electric vehicle drivelines and other powered or corrosive applications to form conductive deposits and corrosion tendencies with copper or other materials. Fluids known to perform poorly in the field have been shown to fail this test and fluids known to perform well in the field have been shown to pass this test. Comparison of fluids using this test is likely to be an indicator of which fluids may have better field performance. This test is recommended in the SAE J3200, Surface Vehicle Information Report Fluid for Automotive Electrified Drivetrains.
Scope
1.1 This test method covers the basic operation of the conductive deposit test. The apparatus is utilized to monitor the formation of dendrites and deposits that are conductive and may form under oxidation conditions of fluids used in electric vehicles and other industries where electronics are involved. The oxidation conditions can vary from 80 °C to 180 °C with very specific circuit boards, under power, and monitoring changes in conductance over time. Both the liquid and vapor areas are monitored for this condition over time. Variables in temperature, voltage, and time can be altered according to the industry need. A reported index based on the rate of deposit formation may be implemented. The typical testing is performed at 150 °C over a period of up to 500 h with a monitored voltage applied.
Note 1: Testing up to 1000 h has some historical significance and is an option but not covered in this test method.
1.2 This test method has an interim precision. An interlaboratory study of this test method is being conducted and a complete precision statement is expected to be available on or before December 2024.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.