Standard
Active
Last Updated: Aug 06, 2019
Track Document
ASTM D8234-19
Standard Test Method for Anions in High Ionic Water by Ion Chromatography using Tandem Suppressed Conductivity and UV Detection
Standard Test Method for Anions in High Ionic Water by Ion Chromatography using Tandem Suppressed Conductivity and UV Detection
D8234-19
ASTM|D8234-19|en-US
Standard Test Method for Anions in High Ionic Water by Ion Chromatography using Tandem Suppressed Conductivity and UV Detection
Standard
D8234 Standard Test Method for Anions in High Ionic Water by Ion Chromatography using Tandem Suppressed Conductivity and UV Detection>
new
BOS Vol. 11.01 Committee D19
$
72.00
In stock
Significance and Use
5.1 Ion chromatography provides for both qualitative and quantitative determination of common anions, F −, NO2−, hydrogen phosphate ion (HPO4–2), Br −, NO3–, and SO4–2, in the milligram per litre range from a single analytical operation requiring only a few millilitres of sample for analysis.
5.2 Anion combinations such as chloride/bromide (Cl − /Br −) and nitrite/nitrate (NO2− /NO3–), which may be difficult to distinguish by other analytical methods, are readily separated by ion chromatography.
Scope
1.1 This test method covers the simultaneous determination of fluoride (F −), nitrite-N (NO2-N), ortho-phosphate-P (o-PO4-P), bromide (Br −), nitrate-N (NO3-N), and sulfate (SO4-2) ions in high saline water (up to 20 % sodium chloride (NaCl)) by suppressed ion chromatography and tandem ultra-violet (UV) detection.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exception—The inch-pound and SI units shown for pressure measurements are to be individually regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.