Standard
Historical
Last Updated: May 24, 2023
Track Document
ASTM D8004-15
Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing
Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing
D8004-15
ASTM|D8004-15|en-US
Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing
Standard
D8004 Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing>
new
BOS Vol. 05.04 Committee D02
$
86.00
In stock
ASTM International
Significance and Use
5.1 This test method provides a means for a reliable field determination of fuel dilution that is quick and preparation-free. Results are obtained in approximately 1 min. Such a method is used, for example, at remote railroad depots where it is impractical to carry out a standard laboratory method for determination of fuel dilution, such as described in Test Method D7593, but it is a critical need to determine if fuel has contaminated the lubricant. If fuel has contaminated the lubricant, this is significantly detrimental to the machinery and it is typically serviced immediately. Further, the fuel can ignite at the high temperatures encountered in machinery lubricant paths.
Scope
1.1 This test method describes a means for determining the amount of fuel dilution present in an in-service lubricant. This is achieved by drawing into a surface acoustic wave (SAW) sensor vapor from the lubricant. Fuel vapor will be absorbed by the SAW sensor’s polymer coating. The amount of absorbance is then related to fuel content in the lubricant.
1.2 The range of fuel dilution capable of being measured by the test method is from 0.1 % to 10.0 % by mass fuel dilution.
1.3 This test method is specifically tailored to determining the fuel dilution of in-service lubricants, including newly utilized lubricants. The method is applicable to contamination with diesel, gasoline, and jet fuels.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.See Section 9.