Standard
Active
Last Updated: Dec 08, 2025
Track Document
ASTM D7865-13(2025)
Standard Guide for Identification, Packaging, Handling, Storage, and Deployment of Fabricated Geomembrane Panels
Standard Guide for Identification, Packaging, Handling, Storage, and Deployment of Fabricated Geomembrane Panels
D7865-13R25
ASTM|D7865-13R25|en-US
Standard Guide for Identification, Packaging, Handling, Storage, and Deployment of Fabricated Geomembrane Panels
Standard
D7865 Standard Guide for Identification, Packaging, Handling, Storage, and Deployment of Fabricated Geomembrane Panels>
new
BOS Vol. 04.13 Committee D35
$
64.00
In stock
ASTM International
Significance and Use
4.1 For a fabricated panel to be properly used, it must be adequately identified and packaged. It must be handled and stored in such a way that its physical property values are not degraded. Failure to follow good practice may result in the unnecessary failure of the fabricated panel in a properly designed application.
4.2 This guide is not intended to replace project-specific storage, handling, identification, packaging, or installation requirements or quality assurance programs.
Scope
1.1 This guide covers guidelines for the identification, packaging, handling, storage, and deployment of fabricated geomembrane panels. This guide is not to be considered as all encompassing since each project involving fabricated panels presents its own challenges and special conditions.
1.2 This guide is intended to aid fabricators, suppliers, purchasers, and users of fabricated panels in the identification, packaging, handling, storage, and deployment of fabricated geomembrane panels.
1.3 This guide is written for factory-fabricated geomembrane panels only. Other geosynthetics use Guide D4873/D4873M as their guide.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.