Standard
Active
Last Updated: Dec 11, 2024
Track Document
ASTM D7662-15(2024)
Standard Test Method for Carbon Content in Carbon Black Feedstock Oils
Standard Test Method for Carbon Content in Carbon Black Feedstock Oils
D7662-15R24
ASTM|D7662-15R24|en-US
Standard Test Method for Carbon Content in Carbon Black Feedstock Oils
Standard
D7662 Standard Test Method for Carbon Content in Carbon Black Feedstock Oils>
new
BOS Vol. 09.01 Committee D24
$
64.00
In stock
ASTM International
Significance and Use
4.1 Measuring the total carbon content of feedstock oil is often a necessary component in calculations for carbon dioxide emissions, estimating yield of a process, or assessing product quality.
4.2 The carbon black industry measures carbon content of feedstock oils along with carbon content of carbon black products per Test Method D7633 for Carbon Black-Carbon Content in calculations to determine carbon dioxide emissions for compliance with governmental greenhouse-gas-reporting requirements.
Scope
1.1 This test method covers the instrumental determination of carbon content in samples of carbon black feedstock oils. Values obtained represent the total carbon content.
1.2 This test method is applicable to carbon black feedstock oils derived from petroleum, coal, and other sources which include fuel oils, residues, tars, pitches, reclaimed oils, and similar materials that are normally handled as liquids. This test method is applicable to products that typically contain 75 to 94 mass % carbon.
1.3 The results of these tests can be expressed as mass % carbon.
1.4 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.