Standard
Active
Last Updated: Dec 22, 2025
Track Document
ASTM D7617/D7617M-25
Standard Test Method for Transverse Shear Strength of Fiber-Reinforced Polymer Matrix Composite Bars
Standard Test Method for Transverse Shear Strength of Fiber-Reinforced Polymer Matrix Composite Bars
D7617_D7617M-25
ASTM|D7617_D7617M-25|en-US
Standard Test Method for Transverse Shear Strength of Fiber-Reinforced Polymer Matrix Composite Bars
Standard
D7617/D7617M Standard Test Method for Transverse Shear Strength of Fiber-Reinforced Polymer Matrix Composite Bars>
new
BOS Vol. 15.03 Committee D30
$
80.00
In stock
ASTM International
Significance and Use
5.1 This test method for transverse shear strength is intended for use in laboratory tests in which the principal variable is the size or type of FRP bars. The test may be used for smooth round rods or on bars with a textured or undulating surface added to promote bond of the bars to Portland cement concrete. This test method establishes values of transverse shear strength for material specifications, quality control, quality assurance, research and development, and may also be used for structural design purposes.
5.2 Experience with this test method and the accompanying fixture is primarily with smooth rods and textured bars with diameters ranging from 6 mm to 25 mm [0.25 in. to 1 in.]. The method may be used for rods or bars of larger diameters, but the overall geometry of the test fixture may need to be increased.
Scope
1.1 This test method specifies the test requirements for (FRP) composite smooth round rods and textured bars for determining the transverse shear strength via a double shear fixture. FRP rods and bars are often loaded in transverse shear when these elements are used as dowels in concrete pavements, as stirrups in concrete beams, or as shear reinforcements in glued-laminated wood beams, for example.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.2.1 Within the text, the inch-pound units are shown in brackets.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.