Standard
Active
Last Updated: Nov 06, 2025
Track Document
ASTM D6937-25
Standard Test Method for Determining Density of Emulsified Asphalt
Standard Test Method for Determining Density of Emulsified Asphalt
D6937-25
ASTM|D6937-25|en-US
Standard Test Method for Determining Density of Emulsified Asphalt
Standard
D6937 Standard Test Method for Determining Density of Emulsified Asphalt>
new
BOS Vol. 04.03 Committee D04
$
64.00
In stock
ASTM International
Significance and Use
4.1 This test method provides a controlled laboratory test for the determination of quantitative volumes of emulsified asphalt for use in bills of lading, invoicing, and application rates.
Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.
Scope
1.1 This test method covers the determination of density of emulsified asphalt used in highway construction. This unit is computed by determining the mass of an emulsified asphalt contained in a standard measure of known volume.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.