Standard
Historical
Last Updated: Dec 16, 2016
Track Document
ASTM D6619-00(2012)
Standard Practice for Incorporating Pigments by High Speed Dispersion
Standard Practice for Incorporating Pigments by High Speed Dispersion
D6619-00R12
ASTM|D6619-00R12|en-US
Standard Practice for Incorporating Pigments by High Speed Dispersion
Standard
D6619 Standard Practice for Incorporating Pigments by High Speed Dispersion>
new
BOS Vol. 06.01 Committee D01
$
77.00
In stock
Significance and Use
High speed dispersion is a commonly used dispersion method in the coatings industry. For the purpose of this practice, “high speed” would normally be understood to be a range of RPM between 3 000 and 10 000. This practice provides a reference for its use, so that a producer and user can standardize on an incorporation technique. This will minimize differences in the millbase, and allow the interested parties to concentrate on the physical, chemical, or optical methods to be run.
Scope
1.1 This practice covers the dispersion of pigments using a laboratory size high-speed impeller mill. It is similar in technical content to ISO 8780-3.
Note 1—This practice is restricted to mill bases of moderately high viscosity due to either high vehicle concentration or high pigment concentration, or both, which can produce high shear force. It is not intended to provide a means of formulating either pilot plant or full-scale mill base compositions (scaling up the process from laboratory equipment to factory mills is not simple).
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.