Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D6334-98(2003)e1
Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
D6334-98R03E01
ASTM|D6334-98R03E01|en-US
Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
Standard
D6334 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence>
new
BOS Vol. 05.02 Committee D02
$
86.00
In stock
Significance and Use
Knowledge of the presence of sulfur in petroleum products, especially fuels, helps predict performance characteristics, potential corrosion problems, and vehicle emission levels. In addition, some regulatory agencies mandate reduced levels of sulfur in reformulated type gasolines.
Scope
1.1 This test method covers the quantitative determination of total sulfur in gasoline and gasoline-oxygenate blends. The Pooled Limit of Quantitation (PLOQ) was determined to be 15 mg/kg. Therefore, the practical range for this test method is from 15 to 940 mg/kg.
Note 1—This concentration range is based on that used in the interlaboratory round robin, which shows that the range of sulfur in the round robin samples was from 1.5 to 940 mg/kg; however, below 15 mg/kg, the reproducibility approaches 100 % of the concentration.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitation prior to use.
1.3 The values stated in SI units are to be regarded as the standard. The preferred units are mg/kg sulfur.