Standard
Active
Last Updated: May 10, 2021
Track Document
ASTM D6050-21
Standard Test Method for Determination of Insoluble Solids in Organic Liquid Hazardous Waste
Standard Test Method for Determination of Insoluble Solids in Organic Liquid Hazardous Waste
D6050-21
ASTM|D6050-21|en-US
Standard Test Method for Determination of Insoluble Solids in Organic Liquid Hazardous Waste
Standard
D6050 Standard Test Method for Determination of Insoluble Solids in Organic Liquid Hazardous Waste>
new
BOS Vol. 11.04 Committee D34
$
64.00
In stock
Significance and Use
5.1 A high percentage of insoluble, suspended solid material can create pumping, filtering, or grinding difficulties in the off-loading of bulk shipments of OLHW and can contribute to excessive wear on processing equipment. High solids can also decrease the quality and consistency of commingled solutions by decreasing the effectiveness of agitation in storage tanks. These issues are of concern to the recycling industries (solvents, paints, and other materials handled in significant quantities) in addition to those activities that propose to use the waste as a fuel.
Scope
1.1 This test method covers the determination of the approximate amount of insoluble, suspended solid material in organic liquid hazardous waste (OLHW).
1.2 This test method is intended to be used in approximating the amount of insoluble, suspended solids in determining the material-handling characteristics and fuel quality of OLHW. It is not intended to replace more sophisticated procedures for the determination of total solids.
1.3 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.