Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D5668-99(2003)
Standard Test Methods for Rubber From Synthetic Sources-Volatile Matter
Standard Test Methods for Rubber From Synthetic Sources-Volatile Matter
D5668-99R03
ASTM|D5668-99R03|en-US
Standard Test Methods for Rubber From Synthetic Sources-Volatile Matter
Standard
D5668 Standard Test Methods for Rubber From Synthetic Sources-Volatile Matter>
new
BOS Vol. 09.01 Committee D11
$
77.00
In stock
Significance and Use
These test methods are mainly intended for referee purposes but can also be used for quality control of rubber production.
The amount of volatiles can affect processing and cure characteristics of compounded rubber.
Scope
1.1 This test method covers four test methods: a hot mill method, two oven methods and a press method for the determination of moisture and other volatile matter content in synthetic rubber.
1.2 Either oven method shall be used especially when the rubber is too tacky to be handled satisfactorily on a hot mill.
1.3 The press method shall be used for rubbers that are too crumbly to be retained satisfactorily on a laboratory mill.
1.4 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.