Standard
Active
Last Updated: Mar 24, 2025
Track Document
ASTM D5641/D5641M-25
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
D5641_D5641M-25
ASTM|D5641_D5641M-25|en-US
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
Standard
D5641/D5641M Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber>
new
BOS Vol. 04.13 Committee D35
$
64.00
In stock
ASTM International
Significance and Use
5.1 This practice is a nondestructive evaluation intended to be used for quality control purposes during factory or field seaming of geomembranes.
5.2 This practice may also be used to evaluate geomembrane panels for holes that penetrate the entire thickness of material. Limitations on the test practice are that it may not be suitable for uneven or curved surfaces, thick seams, seams in corners, and thin extensible geomembranes.
Scope
1.1 This practice covers procedures to perform nondestructive quality control testing described in Practice D4437/D4437M for evaluating the continuity of all types of geomembrane seams using the bubble emission or vacuum chamber method.
1.2 The technique described in this practice is intended for use on geomembrane seams, patches, and defects.
1.3 This practice can only be used when the seam to be tested is at the edge or covering the edge of the welded material, enabling a vacuum to be created.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.