Standard
Active
Last Updated: Aug 06, 2025
Track Document
ASTM D5469/D5469M-25
Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems
Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems
D5469_D5469M-25
ASTM|D5469_D5469M-25|en-US
Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems
Standard
D5469/D5469M Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems>
new
BOS Vol. 04.04 Committee D08
$
72.00
In stock
ASTM International
Significance and Use
4.1 This guide outlines general procedures and precautions necessary for correct and safe application of spray applied polyurethane foam roofing systems.
4.2 This guide is not all-inclusive; this guide is intended only to supplement detailed instructions from manufacturers and safety requirements established by law.
4.3 Refer to Spray Polyurethane Foam Alliance SPFA-104 and The NRCA Roofing Manual: Metal Panel and SPF Roof Systems for industry guidelines.
Scope
1.1 This guide covers the application of new roofing systems consisting of spray applied polyurethane foam insulation, elastomeric protective coatings, and optional mineral granules. This guide does not apply to repair or recoating applications (see Guide D6705/D6705M).
1.2 Design criteria associated with the installation of spray in place polyurethane foam are beyond the scope of this specification.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.