Standard
Historical
Last Updated: Jan 24, 2020
Track Document
ASTM D5454-11e1
Standard Test Method for Water Vapor Content of Gaseous Fuels Using Electronic Moisture Analyzers
Standard Test Method for Water Vapor Content of Gaseous Fuels Using Electronic Moisture Analyzers
D5454-11E01
ASTM|D5454-11E01|en-US
Standard Test Method for Water Vapor Content of Gaseous Fuels Using Electronic Moisture Analyzers
Standard
D5454 Standard Test Method for Water Vapor Content of Gaseous Fuels Using Electronic Moisture Analyzers>
new
BOS Vol. 05.06 Committee D03
$
77.00
In stock
Significance and Use
Water content in fuel gas is the major factor influencing internal corrosion. Hydrates, a semisolid combination of hydrocarbons and water, will form under the proper conditions causing serious operating problems. Fuel heating value is reduced by water concentration. Water concentration levels are therefore frequently measured in natural gas systems. A common pipeline specification is 4 to 7 lb/MMSCF. This test method describes measurement of water vapor content with direct readout electronic instrumentation.
Scope
1.1 This test method covers the determination of the water vapor content of gaseous fuels by the use of electronic moisture analyzers. Such analyzers commonly use sensing cells based on phosphorus pentoxide, P2O5, aluminum oxide, Al2O3, or silicon sensors piezoelectric-type cells and laser based technologies.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.