Standard
Historical
Last Updated: Dec 20, 2022
Track Document
ASTM D5361/D5361M-16
Standard Practice for Sampling Compacted Asphalt Mixtures for Laboratory Testing
Standard Practice for Sampling Compacted Asphalt Mixtures for Laboratory Testing
D5361_D5361M-16
ASTM|D5361_D5361M-16|en-US
Standard Practice for Sampling Compacted Asphalt Mixtures for Laboratory Testing
Standard
D5361/D5361M Standard Practice for Sampling Compacted Asphalt Mixtures for Laboratory Testing>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
Significance and Use
4.1 Samples obtained in accordance with the procedure given in this practice may be used to measure many different properties of a compacted asphalt pavement including, but not limited to, pavement thickness, density, resilient or dynamic modulus, tensile strength, Marshall or Hveem stability, or for extraction testing, to determine asphalt content, asphalt properties, and mix gradation.
Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing/sampling/inspection/etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely assure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.
Scope
1.1 This practice describes a procedure for removal of a sample of compacted asphalt mixture from a pavement for laboratory testing.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.