Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D5322-98(2003)
Standard Practice for Immersion Procedures for Evaluating the Chemical Resistance of Geosynthetics to Liquids
Standard Practice for Immersion Procedures for Evaluating the Chemical Resistance of Geosynthetics to Liquids
D5322-98R03
ASTM|D5322-98R03|en-US
Standard Practice for Immersion Procedures for Evaluating the Chemical Resistance of Geosynthetics to Liquids
Standard
D5322 Standard Practice for Immersion Procedures for Evaluating the Chemical Resistance of Geosynthetics to Liquids>
new
BOS Vol. 04.13 Committee D35
$
77.00
In stock
Significance and Use
This practice provides a standard immersion procedure for investigating the chemical resistance of a geosynthetic to a liquid waste, leachate, or chemical. The conditions specified in this practice are intended both to provide a basis of standardization and to serve as a guide for those wishing to compare or investigate the chemical resistance of a geosynthetic material(s).
This practice is not intended to establish, by itself, the behavior of geosynthetics when exposed to liquids. Such behavior, referred to as chemical resistance, can be defined only in terms of specific chemical solutions and methods of testing and evaluation criteria selected by the user.
Without regulatory approval, this practice does not supersede testing requirements, such as SW 846, Method 9090, stipulated by regulatory agencies.
Scope
1.1 This practice covers laboratory immersion procedures for the testing of geosynthetics for chemical resistance to liquid wastes, prepared chemical solutions, and leachates derived from solid wastes.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 7.