Standard
Active
Last Updated: Jun 06, 2024
Track Document
ASTM D5231-92(2024)
Standard Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste
Standard Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste
D5231-92R24
ASTM|D5231-92R24|en-US
Standard Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste
Standard
D5231 Standard Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste>
new
BOS Vol. 11.04 Committee D34
$
72.00
In stock
ASTM International
Significance and Use
4.1 Waste composition information has widespread applications and can be used for activities such as solid waste planning, designing waste management facilities, and establishing a reference waste composition for use as a baseline standard in both facility contracts and acceptance test plans.
4.2 The method can be used to define and report the composition of MSW through the selection and manual sorting of waste samples. Where applicable, care should be taken to consider the source and seasonal variation of waste.
4.3 After performing a waste composition analysis, laboratory analyses may be performed on representative samples of waste components, or mixtures of waste components, for purposes related to the planning, management, design, testing, and operation of resource recovery facilities.
Scope
1.1 This test method describes procedures for measuring the composition of unprocessed municipal solid waste (MSW) by employing manual sorting. This test method applies to determination of the mean composition of MSW based on the collection and manual sorting of a number of samples of waste over a selected time period covering a minimum of one week.
1.2 This test method includes procedures for the collection of a representative sorting sample of unprocessed waste, manual sorting of the waste into individual waste components, data reduction, and reporting of the results.
1.3 This test method may be applied at landfill sites, waste processing and conversion facilities, and transfer stations.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.