Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D5085-02
Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography
Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography
D5085-02
ASTM|D5085-02|en-US
Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography
Standard
D5085 Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography>
new
BOS Vol. 11.07 Committee D22
$
86.00
In stock
Significance and Use
This test method is useful for the determination of the anions: chloride, nitrate, and sulfate in atmospheric wet deposition.
Fig. X1.1 in the appendix represents cumulative frequency percentile concentration plots of chloride, nitrate, and sulfate obtained from analyses of over 5000 wet deposition samples. These data may be used as an aid in the selection of appropriate calibration solutions. (3)
Scope
1.1 This test method is applicable to the determination of chloride, nitrate, and sulfate in atmospheric wet deposition (rain, snow, sleet, and hail) by chemically suppressed ion chromatography (1). For additional applications refer to Test Method D 4327.
1.2 The concentration ranges for this test method are listed below. The range tested was confirmed using the interlaboratory collaborative test (see Table 1 for statistical summary of the collaborative test).
| MDL (mg/L) (2) | Range of Method (mg/L) | RangeTested (mg/L) | |
| Chloride | 0.03 | 0.09-2.0 | 0.15-1.36 |
| Nitrate | 0.03 | 0.09-5.0 | 0.15-4.92 |
| Sulfate | 0.03 | 0.09-8.0 | 0.15-6.52 |
1.3 The method detection limit (MDL) is based on single operator precision (2) and may be higher or lower for other operators and laboratories. The precision and bias data presented are insufficient to justify use at this low level, however, many workers have found that this test method is reliable at lower levels than those that were tested.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 9.