Standard
Historical
Last Updated: May 30, 2019
Track Document
ASTM D5076/D5076M-13
Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
D5076_D5076M-13
ASTM|D5076_D5076M-13|en-US
Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
Standard
D5076/D5076M Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
Significance and Use
5.1 This laboratory test method can be used on multi-ply roofing and waterproofing systems to measure, classify, and count the voids between felt plies, between insulation layers, and between the membrane and insulation layers. Voids between the felt plies or between the membrane and insulation layer in multi-ply systems can be the seeds for future blisters.
5.2 In one-ply systems, this test method can be used to count and measure the voids in the adhesive in laps and, in adhered systems, in the adhesive between the membrane and the insulation. Voids in the lapping adhesive can be the source of leakage while voids in the lapping adhesive or in the adhesive between the membrane and insulation can be the seeds for future blisters.
Scope
1.1 This test method includes two procedures for measuring the area of voids in the adhesive between materials used in roofing and waterproofing systems. Both procedures require a count of the number of voids.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.