Standard
Active
Last Updated: Nov 22, 2024
Track Document
ASTM D5072-09(2024)
Standard Test Method for Radon in Drinking Water
Standard Test Method for Radon in Drinking Water
D5072-09R24
ASTM|D5072-09R24|en-US
Standard Test Method for Radon in Drinking Water
Standard
D5072 Standard Test Method for Radon in Drinking Water>
new
BOS Vol. 11.02 Committee D19
$
72.00
In stock
ASTM International
Significance and Use
5.1 The most prevalent of the radon isotopes in ground water is 222Rn. This isotope presents the greatest health risk compared to the other naturally occurring radon isotopes if ingested via the water pathway.
Scope
1.1 This test method covers the measurement of radon in drinking water in concentrations above 2 Bq/L.
1.2 This test method may be used for absolute measurements by calibrating with a 226Ra standard or for relative measurements by comparing the measurements made with each other.
1.3 This test method is used successfully with drinking water samples and Type III reagent water conforming to Specification D1193. It is the user’s responsibility to ensure the validity of this test method for waters of untested matrices.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.