Standard
Historical
Last Updated: Sep 24, 2024
Track Document
ASTM D4689-12(2018)
Standard Specification for Adhesive, Casein-Type
Standard Specification for Adhesive, Casein-Type
D4689-12R18
ASTM|D4689-12R18|en-US
Standard Specification for Adhesive, Casein-Type
Standard
D4689 Standard Specification for Adhesive, Casein-Type>
new
BOS Vol. 15.06 Committee D14
$
86.00
In stock
ASTM International
Abstract
This specification covers casein and other protein-based adhesives in the form of dry powder or granular product for use in adhering wood to wood. This specification provides testing procedures and specifies requirements to differentiate the physical, adhesive, and durability properties of commercially available casein and casein-protein adhesives. Adhesives are classified as class B (water resistant) and class C (dry use). Testing procedures include working life, block shear strength, plywood shear test, and storage life. The adhesive shall conform to the viscosity requirement, working life, block shear, tension, and storage life of this specification. Other requirements include instruction sheet, packing, and marking requirements.
Scope
1.1 This specification covers casein and other protein-blend adhesives for use adhering wood to wood. The adhesive type covered by this specification is a dry powder or granular product comprising a mixture of casein, or casein and other protein source, with the necessary dry chemicals to effect solution when the mixture is added to water.
Note 1: Although the term casein adhesive is used throughout this specification, historically, the adhesive subclass described in 1.1 has been known as casein glue. See Terminology D907, adhesive types.
1.2 Limitations—Cooked casein adhesives are not covered by this specification.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following safety hazards caveat pertains only to the test method portion, Sections 8 through 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.