Standard
Active
Last Updated: Dec 05, 2025
Track Document
ASTM D4570-02(2025)
Standard Test Method for Rubber Chemicals—Determination of Particle Size of Sulfur by Sieving (Dry)
Standard Test Method for Rubber Chemicals—Determination of Particle Size of Sulfur by Sieving (Dry)
D4570-02R25
ASTM|D4570-02R25|en-US
Standard Test Method for Rubber Chemicals—Determination of Particle Size of Sulfur by Sieving (Dry)
Standard
D4570 Standard Test Method for Rubber Chemicals—Determination of Particle Size of Sulfur by Sieving (Dry)>
new
BOS Vol. 09.01 Committee D11
$
77.00
Out of stock
ASTM International
Significance and Use
3.1 This test method is used to evaluate sulfur for suitability as a rubber vulcanizing agent. Sulfur particles must be small enough to dissolve in rubber during cure to produce a uniform network of cross-links. This test method is used as a quality control method to ensure that large particles are not present (and to determine if the sulfur follows a typical pattern for size distribution).
Scope
1.1 This test method covers the particle size measurement of the coarse fraction of ground sulfurs. It is limited to measurement of particles greater than 45 μm (No. 325 sieve). If the sulfur is very fine and the screens become plugged by the caking of the sulfur, it may be necessary to use a wet sieve procedure instead.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.